How do you sprig grass

You simply toss shredded stems evenly over a prepared, moist soil bed, then cover them with a light layer of soil. Invariably some will be completely buried and fail to grow, but the roots of most sprigs will take hold. The furrow method is more time-consuming. Dig 3-inch-deep furrows in the soil 4 to 12 inches apart. Plant each sprig so that the roots are buried and the foliage is above soil level when the furrow is smoothed over.

Whichever method you choose, aftercare is critical. Walk over the area or roll it with a lawn roller at half weight to firm the soil around the crowns of the newly planted sprigs. Water immediately after planting.

Continue watering frequently so the young plants don't dry out while they become established. Keep the area free of weeds. It may be necessary to fill in between the sprigs with extra soil to bring the planting bed up to grade level. This helps the horizontal runners sent out by the sprigs establish themselves quickly. June 09, Save Pin FB More. Lawn Plugs. Step 1. Lawn Plugs and Sprigs: Step 2.

This will help keep the sprigs from drying out and dying. As with seeding, soil must be kept continually moist, not wet, until adequate rooting has occurred. Watering lightly once or twice daily will be required for several weeks after planting. Mulching can also be used in vegetative planting for moisture conservation and erosion control. Another method of sprigging, which is used where rapid cover is needed, is stolonizing or broadcast sprigging. Sprigs are prepared by mechanical shredding or hand tearing of sod into individual sprigs, or purchased by the bushel most common with bermudagrasses.

The material is broadcast, like a mulch, over the area by hand. There are several ways to plant sprigs. Whichever method you use, it is always best to work with slightly moist soil. In any case, do not let the stem dry out.

Water sections as you plant them, and keep the soil constantly moist until the stems are established. One planting method is to cut 2- to 3-inch-deep furrows in the sod bed and place the sprigs in the furrows. Dig the furrows with a hoe and space them from 4 to 12 inches apart, depending on the rate of coverage you would like. Close spacing results in more rapid coverage, but naturally involves more material and labor.

Place the stems against one side of the furrow so that any tufts of foliage are above ground and the light-colored stem is below ground. You should mow for the first time when sprigs have grown three inches tall. Mow to the length of two inches the first two times you mow. You can mow your Bermuda Grass to a regular height of around. This step is best taken when the sprigs have had a few weeks about 6 to establish themselves.

Once you have completed the first two mows you can start spraying for weeds without worrying about the roots of your Bermuda Grass. Check the PH level of your lawn before you plant your sprigs. You can get a soil test from any hardware store or most online retailers. You can use lime on your soil if your PH is low.

If your PH is too high, use Sulfur. Bermuda grass grows laterally and will fill its own spots. If your grass is thin near the end of the season make sure sun, water, and nutrients are correct. Water is important to establish your lawn. Make sure your grass does not get dry.

Bermuda Grass is drought resistant it needs lots of water in the beginning.